Rigid anchor line CE certification PPE certification cycle: 5-7 days rigid anchor line, using rail or rope. Rigid anchor line material, shall comply with EN 354: 2002 requirements of Section 4.2.3, the minimum diameter of 8 mm, or take other values ??can provide an equivalent security. In order to limit lateral movement of the rigid anchor line spacing should be recommended in a fixed structure. If rigid anchor rope wire rope, wire rope should be fixed in the structure, and the rope taut. Shall be suitably designed anchor line, the guide type fall arrester can only move in a particular direction, and oriented to prevent any accidental fall of the braking apparatus from the anchor rope shedding. All attachment / detachment point rigid anchor line, configuration pinned end face only, or you can configure only the end face pinned to prevent oriented fall unconscious from the anchor rope brakes. Oriented type fall arrester shall be equipped with a connector or connector terminals lanyard. If the fall arrester is equipped with only one connecting member, the connecting member may be permanently connected to the brake device during a fall, can be disengaged from the fall arrester. If the fall arrester is equipped with a lanyard, one end of the lanyard should be permanently attached to the fall arrester, the other end of the lanyard should be connected to a connector. A horizontal distance shall be specified by the manufacturer, and inform the manufacturer's information inside (see 7a). Lanyard can be made of synthetic fiber ropes, wire rope, fabric belt or chain. Lanyard materials shall comply with standard EN 354: 2002 4.2.2, 4.2.3 and 4.2.4 The provisions of this Article.